Have you ever been to the navy boot camp bathrooms before? Or are you joining the navy soon and asking yourself endless questions like; is there adequate hot water? How long do soldiers in the navy take to shower, or what time do they go to the bathroom?
Well, once in the navy, there’s no way to escape communal showers. Everyone in your regimental headquarters will enter the bathroom in the barracks when it’s time to do so. The navy boot camp bathrooms are large and tiled, and multiple shower heads are mounted along the walls. But why is this necessary? Ok, take your time and scroll to the end of this article to find out more.
As stated earlier, soldiers take communal showers. This type of showering is referred to as combat showering. It allows for significant water and energy savings by turning off the water in the middle of the shower while lathering. This shower usually lasts less than two minutes – with only 30 seconds to get wet, turning off the water shower head, using shampoo and soap and lathering, and finally rinsing off thoroughly.
Using this method, they could stay clean and still use their scanty water supply. Some people are adopting this method to help them conserve water and energy required to heat water for both economic and environmental reasons. The United States Department of Energy claims that water heating is the second most expensive way to expend energy in a house – (following space heating).
You will save money by taking showers that waste little water and take little time. A shower that uses a lot of water can waste approximately 60 gallons of water, whereas a shower in the navy can consume only 3 gallons of water. The Navy invented this technique to help keep the freshwater supply in ships, which is how it saves you money when it comes to the water bill. It’s also eco-friendly.
Below is a short video on how to shower in a Bootcamp:
How To Prepare Before Going to The Navy Boot Camp Bathroom to Take a Shower
If you’re new in the navy army, here is a step-by-step guide to getting you started.
1. Take a quick look at the water that flows when you shower. If it flows at a buck per minute, that is equal to 5 gallons of water. You can quickly do this easily by taking a small bucket that holds about one gallon and gauging how long it will take for your bucket to fill up. If you can fill up your bucket quickly and shower for 15-minute, it implies that you will use about 15 gallons of water.
If you shower in the navy boot camp bathrooms, you want to use less water than usual – approximately 3 gallons. To achieve this goal, you need to know what your average water consumption is.
2. Use the information you’ve gathered concerning the rate of flow of your shower to figure out how much water you use per shower. You will find out how much water you use per minute by multiplying the total amount of water you consume in one minute by the total number of minutes you shower each day.
The typical shower uses approximately four gallons of water per minute to achieve its flow rate. Therefore, if you cannot accurately measure your flow rate due to some reason, you can use this number to determine how many gallons you will need to take your shower.
3. Make the most of your shower by increasing the flow rate. A flow controller is used to help you control the rate at which your shower water flows. If reducing energy consumption is the goal, this is a worthy addition to the shower.
Taking The Shower
1. Turn on your water and allow it to warm up. If you are doing this to save on water bills and environmental resources purposely, you should make good use of the cold water by putting a bucket over to collect some water that you may use later for shaving your legs.
2. Make sure you thoroughly wet your body and wash your hair. Step into the hot shower and swiftly get yourself wholly wet. Then turn off the water. Use a washcloth or your hands to submerge your body in water thoroughly, and then turn on the water.
3. Apply shampoo to your hair and soap on your body. It should be done while the shower is on. You can use a washcloth or another towel to help you scrub yourself thoroughly. You won’t enjoy the regenerative benefits of running water, such as its cleansing properties.
Take your shower quickly, particularly if you’ve got an inefficient water heater. If you wait too long, you may not be able to get warm water. Furthermore, taking too long can cause unpleasant temperature swings.
4. Rinse and wash your body with your favorite soap and shampoo. After you’ve thoroughly cleaned yourself, give yourself a quick blast of water from the shower.
5. Add a conditioner to your hair if you want it conditioned. A quick shampoo blast through your hair will remove any remaining product. When your hair is thoroughly rinsed, turn the water back on and rinse it off.
FAQs
Do navy boot camp bathrooms save money?
Some people think showering can only take 60 gallons, while a shower in the navy bathroom can only use 3 gallons of water. Doing our mathematics, one person may save up to 15,000 gallons of water a year!
Do sailors shower often?
Sailors only get two showers a week at sea, and a transatlantic crossing may be even shorter. You need nothing more than some dry shampoo and a few reusable baby wipes if you are a sailor. But if you do get the luxury of showering, it is often very sweet but short.
Do bathroom stalls exist at the navy boot camp?
If you walk into any male recruit’s head (aka the restroom) at the Recruit Depot, you’ll notice that there are no doors on any of the bathroom stalls or even on the toilets. Even though Marine Corps Recruit Depot is a place where recruits are used to having optimum privacy, there is none in navy boot camps.
Wrap Up
Navy boot camp bathrooms are more like prison bathrooms with about 8 – 10 showers. Nobody will look at the size of your peener; everyone is too concerned with quickly getting in and done with the shower. It ensures that not much time is spent in the bathroom and helps avoid the scenario of long queues. A strange recruit code usually kicks in after everyone has settled down. So, no need to worry!